- Also in this section:
- Wiring Accessories
- Lighting Control Info
- Analogue Dimmers
- Digital Dimmers
- Full Technical Details
Plate Materials
| Steel | Brass | Wood | Gasket |
| 304 Grade Stainless Steel |
CZ 108 (Minimum 60% copper content, coated with electro-phoretic lacquer and heat-cured at 160°C for minimum 25 minutes) | From sustainable forests where possible. Backed by ridged PVC with electrical insulation. Meets requirements of BS3757:1978 |
Fitted white of black plastic or flat clear supplied where appropriate |
|
Cleaning Plates |
Linea Range Plates |
| Use a soft cloth. No abrasive medium to be used to clean plates. | Install the frame with the notch at the bottom |
Plate Profile Depths
| Sheer/Henley | 1.5mm |
| Sheer CFX | 4.4mm |
| Hartland | 5mm |
| Hartland CFX | 5mm |
| Georgian Styles | 10.8mm |
|
Edwardian & Victorian |
8.5mm |
| Woods | 11mm |
Special Note
When mounting Henley or Sheer flat plates on to dry lining boxes due to the construction of the wall box having a lip at the front, the flat plate sits on this lip and the lip is therefore visible, this problem does not occur when using plates with a return edge profile.
Wiring Accessories
 |
 |
 |
 |
| Shaver Sockets | Inserts | Screws | 13amp Sockets |
| Dual voltage: 115/230 output (220/240 input) These are to be used for shavers only. | Grid and Monobloc types, designed to comply with appropriate BS & IEC standards and approvals. | 30mm screws are supplied as standard; longer (50mm) are available in packs of 100. | Only 13amp 3 pin plugs to be used in 13amp 3 pin sockets. |
Shaver Sockets |
13amp Sockets |
||
Hairdryers, chargers etc. must NEVER be plugged in shaver sockets. |
2 pin round plugs must NOT be inserted. Round pins can deform the live & neutral barrels within the sockets & cause it to overheat under load.  |
||
Printed Symbols
| Printed symbols available on GRID-IT 20amp DP rockers |
 |
|||
 |
 |
 |
 |
|
 |
 |
 |
 |
|
 |
 |
 |
 |
|
 |
 |
Click an insert to enlarge | ||
E&OE